How to Boost Your WiFi Signal by a Beer Can

Today I will introduce you a simple WiFi booster, which has been shown to increase signal strength by at least 2 to 4 bars. I saw this method from website which I think it is worth to tell everybody. First of all you need to prepare scissors, a utility knife, some adhesive putty and an empty bear can. Remember only one can is needed per router, it is not a good reason to get drunk.

wifi signal boost

wash the empty beer can

wifi signal boost

remove the pull tab

wifi signal boost

cut off the bottom

leave the white line uncut

leave the white line uncut

wifi signal boost

cut opposite to the piece

wifi signal boost

Attach to router

 

 

 

 

 

 

 

 

 

 

First of all, you need to wash out your empty beer can. Once the can has dried, you will need to remove the pull tab. Second step is to cut off the bottom of the can by the utility knife. The third is to cut the base through the red line as shown on the picture. Be careful! Do not cut it off! Leaving a little of metal where near the hole which shown on the picture of the white line. This action is making sure to keep the base attached. Forth, you need to cut opposite to the piece of the metal straightly. Please keep in mind that you need to make sure the base is attaching. Now you are done! Just use the adhesive to attach your modded beer can to the WiFi router, your WiFi signal is successfully boost! Try it! If you need a WiFi router, simply click here to browse the router section of PrimeCables.com.

Posted in How to, Tutorial Tagged with: ,

Leave a Reply

Your email address will not be published. Required fields are marked *

*